For me it’s driving while under the influence. If you couldn’t tell, I like me some ganja. However I have long since held the belief that it is utterly insane to drive while under the influence of most substances, with maybe nicotine and caffeine being the exception. All too often I see other stoners smoking and driving, which I simply can’t fathom. I’ve only operated a vehicle once under the influence and it was just to move a U-Haul around the block to a different parking spot, which was such a scary experience while high that I refuse to even consider getting behind the wheel again while high.
Really? I bought an Ender 3 V2 three years ago which is quite famous in the ‘scene’ but also famous for a number of issues. As a newbie I asked a lot of beginner questions and I constantly received very supportive and helpful answers.
‘Yeah that’s a known issue but you can tweak X, change setting Y or replace part Z to work around it’
Same experience with the FreeCAD community. Amazing people and a software that works pretty well with some initial exercise.
I see an increasing amount of Prusa folk vs Bamboo folk (and vice-versa), everyone vs fusion360 folk (and to a lessor extent vice-versa). And very recently I’ve started to notice a new vocal “I only ever use thangs.com” group starting to sprout.
There’s a lot about the hatred of Bambu that’s just sinophobic. Which is too bad because there’s plenty of completely rational reasons to avoid Bambu printers.
That’s weird because all except prusa are Chinese made. My issue with Bambu is that it is a closed ecosystem, but they are undeniably very capable machines.
God I wish people would shit on the ender 3 V2 more. I wish I would have given up on that pile of junk sooner. “You get what you pay for” absolutely applies. No amount of tweaking could make that thing print consistently unless you could consistently awful.